Installing The Camera; Attaching The Sunshield - Beward N6603 User Manual

strength from the electric cables exceeds 3 V/m, you should increase the distance
between the electric and feeble-current cables or reduce the electromagnetic noise.
 Twisted pair and electric cables should cross each other at right angles.
 Unshielded twisted pair cables should be located at distance of at least 125 mm from
fluorescent gas-discharge lamps or from other high-voltage discharge devices.
 Unshielded twisted pair cables should be located at distance of at least 1.5 meters from
electromagnetic interference sources that produce electric field strength exceeding 3
V/m.
 Switchboards with pinned unshielded twisted pair cables should be located at distance
of at least 3 meters from electromagnetic interference sources that produce electric field
strength exceeding 3 V/m.
 Entire twisted pair cables should be arranged between the points of connection so the
cable run is as short as possible.
 Minimum cable bending radius is four times the cable diameter (or 1 inch=2.5 cm) or it is
also acceptable to install the cable so the cable bending radius is 2 inches (5 cm).
 Maximum length of the entire segment is 100 meters.

4.3. Installing the Camera

4.3.1. Attaching the Sunshield

If necessary, you can attach the sunshield to the camera. It is fastened with two screws,
which are included with this camera.
Step 1: fasten the sunshield with two screws. To prevent damaging of the sunshield, insert
the supplied plastic washers between the sunshield and the screw head. Adjust the sunshield so it
can easily slide in forward and backward direction.
Step 2: slide the sunshield to the desired position (Pic. 4.3).
N6603 Installation User Manual
Chapter 4. Installing the Camera and Connecting a Cable
Pic. 4.3
13