3.1. Side Panel
Camera's housing consists of a base and a cover.
Base: this part of housing contains hardware components of the camera. The sunshield
and the bracket are attached to the base.
Cover: this part of housing protects the camera lens and IR LEDs against physical and
environment influence. The cover is screwed onto the base using a threaded connection.
NOTE:
The transparent part of the cover is a part of the camera's optical system. To prevent scratching, please
do not touch the transparent part.
IMPORTANT!
The cover is screwed onto the base by the manufacturer under special conditions that provide for housing
tightness. If unscrewing the cover, you should take notice of the tightness and humidity. The camera must
be assembled in a dry atmosphere in humidity conditions that are lower than 20 – 30%. Otherwise it may
cause condensation on the camera front cover glass.
N6603 Installation User Manual
Chapter 3. Physical Description
Pic. 3.1
Chapter 3. Physical Description
7