Table of Contents
Advertisement
ALTERNATE
CONNECTION:
If local codes do not permit the
connection
of a frame-grounding
conductor
to the neutral wire:
STEP 1. Make sure the power supply to
the dryer is off.
STEP 2. Make sure the power supply
cord or direct wire cable is in place (see
steps 1-3 on pages 12-13 for power cord
connections
or steps 1-3 on pages 13-14
for ,direct wire connection).
STE=P 3, Remove the neutral grounding
wire (green/yellow wire) from external
grounding
connector
screw. Loosen or
remove terminal block screws. Connect
neutral grounding
wire and the neutral
wire (white or center) of power supply
cord or direct wire cable under the center
screw of the terminal block.
STEP 4, Connect the other two wires
to outer terminal block screws. Tighten
all terminal block screws firmly.
STEP 5, Tighten the strain relief screws.
STEP 6, Insert tab of terminal block
cover into slot of the dryer rear panel.
Secure cover with hold-down
screw.
STEP 7, Connect
separate copper
grounding
wire from external ground
connector
to an adequate
ground.
If
codes permit and a separate grounding
wire is used, it is recommended
that a
qualified electrician
determine
that the
grounding
path is adequate.
Proceed with Exhaust
Installation.
See "CONNECT
EXHAUST"
on
page 19.
External
ground
connector
Neutral
grounding wire
(green/yellow)
Grounding path
determined bya
qualiliedelectrician
Alternate
3-Wire Connection
with
External-Grounding
Conductor
15
Advertisement
Table of Contents
