Table of Contents
Advertisement
12
I. THREE-WIRE
ELECTRICAL
CONNECTION
TO RECEPTACLE
Use a 3-wire power supply cord:
Electrical
Shock
Hazard
Turn power supply off before
connecting cord.
Use a new 30-ampere power
supply cord.
Plug into a grounded
outlet.
Failure to follow these instructions
can result in death, fire, or
electrical shock.
Local codes may permit the use of
a U.L.-listed,
120/240-volt
minimum,
30-ampere,
dryer power supply cord
kit (pigtail). Power supply cord should
be type SRD or SRDT and be at least
four feet long.. The wires that connect
to the dryer must end with ring terminals
or spade terminals
with upturned ends.
Spadeterminals_
,__
with upturned ends
_
Thisbladeconnected
Ring
NEI_
to this co_
s
strainrelief
(white or center)
Three-wire power supply cord
The power supply cord must have three,
No.-10 copper wires to match a three-
wire receptacle
of NEMA Type 10-30R.
I_
hree-wire
receptacle
•
(NEMAType
10-30R)
Do not use an extension
cord with
this dryer.
Do not connect
plug end of power
supply cord into a live receptacle
before connecting
power supply cord
to dryer terminal block.
GROUNDING
INSTRUCTIONS
This appliance
must be grounded.
In the event of malfunction
or break-
down, grounding
will reduce the risk
of electric shock by providing a path
of least resistance
for electric current.
The power supply cord must be plugged
into an appropriate
outlet that is properly
installed and grounded in accordance
with all local codes and ordinances.
WARNING:
Improper connection
of the
equipment-grounding
conductor
can
result in a risk of electric shock. Check
with a qualified
electrician
or serviceman
if your are in doubt as to whether the
appliance
is properly grounded.
Do not modify the plug on the power
supply cord. If it will not fit the outlet,
have a proper outlet installed by a
qualified
electrician.
STEP 1. Turn power supply off.
STEP 2. Remove hold-down
screw
and terminal block cover.
Hold-down screw
Terminalblockcover
Advertisement
Table of Contents
