20
ROUTE
THE VENT
Typical installations
exhaust from the
rear of the d .ryer.
Avoid pushing the dryer tightly against
a 'wall. This can crush or kink the vent.
Use the straightest
path you can, where
possible. Avoid 90 ° turns.
Rear exhaust installations
for standard
offset connections
- (see pgs. 21-22)
Rear exhaust installations for offset
connections
with close clearances-
(see: p. 23)
This dryer may be converted
to exhaust
out the right or left side or through the
bottom. To convert the dryer, the following
kits must be used.
Exhaust Kit No. 279818 (white)
Exhaust Kit No. 279819 (almond)
Exhaust Kit No. 279820 (ebony)
Follow the instructions
in the kit to
avoid operational
and personal
hazards.
These kits are available at your local
Sears store or Sears Service Center.
Typical installations for left or right side
exhausting
Typical installations
for bottom exhausting
G