Standard Accessories; Electrical Requirements; Installation Instructions - Tadiran Telecom ANL-100 Service Manual

SKY
INSTALATION INSTRUCTIONS
7.1 General
These instructions are intended as general guidelines. The instructions refer to ANL and AVL
products. The air conditioner must be installed by trained and authorized personnel.
Use 7/8" and 1/2"copper tubing for connecting the outdoor and indoor units:
The installation must be performed in accordance with manufacturer's specifications using only
approved tubing, original cables and original accessories.

7.2 Standard Accessories

Outdoor sensor TH3
10 m. Connecting cable
Display cable 8m.

7.3 Electrical Requirements

• The air conditioner must be directly connected to an appropriate power supply.
• Use only type "G" or type "C" fuses as follows:
For ANL-100 and AVL-100 use 3X32A.
For AVL-120 and AVL-140 use 3X40A.
• Use only a single length power cable, without extensions.
• For 3 Phase connections, use 8 wire inter-unit cables.
NOTE: The compressor is equipped with oil heating element. Main circuit breaker and
power supply must therefore always be ON.
If disconnected, make sure that power supply was ON at least 6 hours before starting the
unit.
Absorbtion cushions
Insulation for fittings
Fig. 7-1
- 25 -
User's manual
Wall mounted unit (RT)