Convection Bake Mode - Thermador C302 Service Manual

Convection Bake Mode

Sequence Of Events:
1) K8, K9, K11 relays close.
2) K4 relay energizes both cooling motors; airflow from cooling motor closes
the "air switch" contacts. The completed "air switch" circuit signals the
board {signal voltage). Note: If the air switch circuit /s not completed
within 40 seconds, the board will interpret a cooling fan fault and display
an F34 error code for the upper oven, and an F64 error code for the lower
oven.
3) K11 relay closes and activates the convection motor. Note: The convection
motor will stop when the oven door is opened during any convection
mode.
4) Pin header P14 on the relay board sends 24 VDC to the double line break
relay (DLB) coil. When the coil is energized; the DLB contacts close.
Current flows from L1 to one leg of the bake, broil, and convection
elements.
5) Bake relay K8 and broil relay K9 alternately open and close and send
current from L2 to the other leg of the bake and broil elements the bake
element is on for 56 seconds, and the broil element is on for 4 seconds
during each 1-minute cycle.
Page 72