One+8" Intercom Toggling Mode - scala rider G9x User Manual

Intercom communication is possible using one of the three
Intercom modes:
Section "One+8" Intercom
5.1 Toggling Mode
(between scala rider
G9 / G9x and cardo
SHO-1 only)
Section Intercom via Channels
5.2 "A" and "B" (with any
Cardo intercom model)
Section Click-to-Link
5.3
(with compatible
models)
|
scala rider G9x / G9x PowerSet
®
8
2-way Intercom conversations
within a group of up to eight other
"One+8" Buddies
Intercom Conferencing (2-way,
3-way and 4-way) using Channels
"A" and "B"
1-on-1 spontaneous intercom
conversations with random riders
near you who are not already
paired to your scala rider G9x

"ONE+8" INTERCOM TOGGLING MODE

5.1
Pair with up to 8 other devices ("One+8" Buddies) and
connect with them one at a time by saying their name.
5.1a CONFIGURING YOUR BUDDY NAME
Before using "One+8" Intercom, you should assign your device a
Buddy Name, so that other "One+8" participants can call you by
this name.
If you change your Buddy Name, you must pair again with your
"One+8" Buddies for their device to receive your new Buddy Name.
Visit the Cardo Community to configue your Buddy Name (see
Section 3). Until you configure a Buddy Name, your unit will be
known by its generic "One+8" Buddy name, "scala rider G9x".
In Standby, tap
Hear Your
the Buddy name of your scala rider G9x through the
Buddy Name
speakers.
Play Paired
In Standby, press
Buddy List
5.1b PAIRING WITH A "ONE+8" INTERCOM BUDDY
There are three ways to pair with "One+8" intercom buddies:
OPTION 1: Pairing via the Cardo Community®
Easily find and add your friends to your "One+8" Buddy list via the
Cardo Community at: http://community.cardosystems.com
OPTION 2: Flash-Pairing™ (with other G9 or G9x models)
Use Flash-Pairing to pair within seconds.
1. Remove both G9 units from their Audio Kits and check
they are in Standby (slow single blue flashing).
2. Bump the two G9 units gently against each other and hold them
side by side.
and simultaneously. You will hear
for 2 seconds