Listening To Music Via The Aux; Fm Radio; Radio Tuning - scala rider G9x User Manual

[SENDER] Start/Stop
sharing your music:
[RECEIVER] Stop music
sharing:
Phone/Intercom calls and GPS audio navigation will override music
playback.
Music Sharing does not transmit voice audio and cannot be used as
an Intercom call.

6.5 LISTENING TO MUSIC VIA THE AUX

The USB / AUX jack can be used to connect a non-Bluetooth audio
source with a 3.5 mm / 1/8" stereo jack using the enclosed cable.
1. Check that the scala rider is in Standby.
2. Connect the MP3 cable to the Music Player's jack and insert the
other end of the cable into the USB/AUX jack.
To listen to music from a cable-connected device, operate the
Music Player using its buttons as usual (FF/REW/ PLAY/PAUSE).
|
scala rider G9x / G9x PowerSet
®
14
During A2DP music playback, press
2 seconds
Press for 2 seconds

7. FM RADIO

for
Your scala rider G9x includes a built-in FM radio with a
6 Preset memory and RDS (Radio Data System).
RDS allows the radio to automatically retune to the
strongest frequency available for the FM station you
are listening to when the signal becomes too weak.
Radio On
Radio Off
Next Station
Previous Station Use Voice Command
RDS ON/OFF
(Default: Off)

7.1 RADIO TUNING

Preset stations can be saved via the Cardo Community or directly
from your scala rider G9x.
AUX
1. Turn on the Radio.
2. Select a Preset number you wish to set (Preset 1 – 6) by tapping
until the desired preset is heard.
3. Find an FM station to save using Seek or Scan (see 7.1).
Seek and Save: (Find the next FM station)
1. Press or for 2 seconds.
• searches upwards (higher frequency) for a station
• searches downwards (lower frequency) for a station
2. Tap within 20 seconds of finding the FM station to save it as
the current Preset.
In standby, press for 2 seconds or use Voice
Command
Press for 2 seconds or use Voice Command
With radio ON, tap or use Voice Command
With Radio ON, press and simultaneously for
2 seconds