1. Manuals
  2. Brands
  3. scala rider Manuals
  4. Headsets
  5. G4 PowerSet
  6. User manual

scala rider G4 User Manual

Bluetooth headset
Hide thumbs Also See for G4:
Table of Contents

Advertisement

Quick Links

PAGE 1 / 28
DRAFT

Table of Contents

2. CONTENT OF RETAIL BOX
Turning On/Off
Volume Control
Muting
Redialing
a. Mounting the G4 on your helmet
c. Attaching and removing the G4
6. THE SOUND OF MUSIC: FM RADIO AND CABLE CONNECTED
MP3
a. The built-in FM Radio
b. External cable-connected MP3 Players
7. CONNECTING BLUETOOTH DEVICES: MOBILE PHONE, MP3
PLAYER (
c. GPS
), GPS
via A2DP
)

Advertisement

Table of Contents
loading

Related Manuals for scala rider G4

Summary of Contents for scala rider G4

  • Page 1: Table Of Contents

    Voice Feedback c. Audio Sources and Priorities d. Firmware Upgrade Option 5. GETTING STARTED a. Mounting the G4 on your helmet b. Positioning the microphone & speakers c. Attaching and removing the G4 d. Using the flip-up antenna 6. THE SOUND OF MUSIC: FM RADIO AND CABLE CONNECTED a.
  • Page 2 Four-Way Conference Mode Intercom Pairing between 2 couples ( 2 bikers and their passengers riding on two motorcycles 9.3. Using the G4 for INTERCOM with earlier scala rider models a. Two-Way Intercom pairing b. Three-Way Conference Mode Intercom pairing 9. NOTICES a.

  • Page 3: Introduction

    (supporting the Bluetooth A2DP profile, compatible with a variety of MP3 Players, adapters and other audio devices**) 3. as a 3-Way Bike-to-Bike Intercom for conference calls with up to two other scala rider G4 or Q2 headsets (up to 1 mile / 1.6 km. range between two G4 headsets and in Full Duplex*** mode) 4.
  • Page 4 Please check the local regulations and act accordingly. < Insert images of both audio kits and label all buttons/sections > Please not that the scala rider G4 is also available with a corded microphone version for Full-Faced helmets. Two ultra-slim speakers Noise canceling microphone...

  • Page 5: Charging The Headset

    Radio FM Button IMPORTANT: The scala rider G4 is a water-resistant device, designed for use under moderate rain or snow conditions. However, the headset is not rated waterproof and should not be used under severe weather conditions. The cover lid protecting the Charging Jack should be kept tightly closed at all times to prevent moisture from entering the device.

  • Page 6: Basic Setup And Configuration

    Red light = Battery is almost empty VOICE FEEDBACK You scala rider G4 headset offers various audio status messages sent through your speakers. Among others, it will announce your connection state, e.g. whether you are in mobile phone or on intercom mode, it will confirm changes of such modes and more.

  • Page 7: Audio Sources And Priorities

    PAGE 7 / 28 AUDIO SOURCES AND PRIORITIES The different audio sources connected to the G4 are prioritized as shown below, i.e. the higher priority source will always override and interrupt the lower one. For example, incoming mobile phone calls will interrupt ongoing Intercom calls, while incoming intercom calls will interrupt the audio from the built-in FM Radio etc.
  • Page 8 PAGE 8 / 28 • Glue Plate Method: Recommended for helmets to which the standard method cannot be applied, using the Glue Plate included in the box. Pic showing both methods Standard Method: Fastening the Clamp to the Helmet 1. Use the enclosed Allen Wrench to loosen the two screws on the Back Plate. 2.

  • Page 9: Positioning The Microphone & Speakers

    PAGE 9 / 28 b. Peel the foil cover from the adhesive Velcro pad and place the Velcro pad on the chosen location opposite your mouth. c. Attach the microphone on the Velcro, as in photo. d. Tighten the screws of the Clamp. POSITIONING THE MICROPHONE &...
  • Page 10 Built-In FM Radio and external MP3 Player ( via cable a. FM RADIO The scala rider G4 is equipped with a high-quality FM Radio receiver, allowing you to choose how and when you listen to your favorite stations. Turn on Radio...

  • Page 11: Mobile Phone

    All these external devices must be Bluetooth compatible a. MOBILE PHONE To use your mobile phone with the scala rider G4, you must first pair your headset to the mobile phone. Pairing is a one time process. Once the headset is paired to a specific mobile phone, they will remain paired and automatically recognize each other whenever they are within range.
  • Page 12 3. Search for Bluetooth devices on your phone by following the phone’s instructions. Consult your phone’s User Manual for more information. 4. After a few seconds the phone will list “scala rider G4” as a discovered device. Select it and follow your phone’s instructions to accept the pairing.
  • Page 13 PAGE 13 / 28 When the headset is on an active phone call, any Intercom call request will be automatically rejected. Once the phone call is terminated, you can initiate and accept Intercom calls. STATUS LIGHTS LED Indication: Status: None Headset is off 1 blue flash every 3 seconds Standby - No call is in progress...

  • Page 14: Mp3 Player

    NOTE: When pairing two Bluetooth audio devices to the scala rider G4, please follow instructions below . Bluetooth Stereo device pairing will vary depending on the combination of Bluetooth devices you are using.
  • Page 15 NOTE: If using a Bluetooth adapter, follow the device’s instructions for Pairing to Bluetooth headsets. Please consult the device’s User Manual for more information. 4. After a few seconds the MP3 Player will list “scala rider G4” as a discovered device. Select it and follow your MP3 Player’s instructions to accept the pairing.

  • Page 16: Intercom

    Your scala rider G4 can also conduct Intercom communications with earlier scala rider models in different configurations and you can always change your preferences. There are four earlier scala rider models available that your G4 can connect to, and each of these connections comes with specific characteristics and / or limitations.
  • Page 17 PAGE 17 / 28 Section 9.3 explains how to pair your G4 with earlier, non-G4 scala rider models, such as the “Q2 ”, "Solo ", the "FM ", or a "TeamSet " Driver unit. Initiate Intercom calls There are two ways to start an Intercom call with your paired headsets while the headset is in...

  • Page 18: Using The G4 For Intercom With Other G4 Headsets

    Automatic Reconnection of the Intercom If the G4 and another paired headset go out of range and disconnect from each other, the G4 will immediately try to reconnect to the other headset.
  • Page 19 PAIRING OPTIONS BETWEEN THREE PARTICIPANTS ( between scala rider G4 models only) Pairing three G4 headsets is achieved by simply repeating the procedure in the above section TWO- WAY INTERCOM with a second paired G4 headset (in a different CHANNEL).
  • Page 20 FOUR-WAY INTERCOM When connected to three other scala rider G4 units, your headset can also participate in a 4-way Conference Intercom Call (full duplex) as explained below. 4-Way Intercom between up to two couples on two motorcycles...
  • Page 21 Step B: Pair Driver (3) to Passenger (4) Repeat the above pairing procedure with both headsets 7. Using the above two scala rider G4 headsets, follow the instructions below. Step C: Pair Passenger (2) to Passenger (4) Repeat the above pairing procedure with both headsets 8.
  • Page 22 1. If either headset is turned OFF, turn it ON by pressing and holding either the Mobile Button for the G4 unit or the CTRL Button for the Q2 unit until the Blue Light flashes three times. 2. Make sure that both headsets are now flashing slowly in Blue.
  • Page 23 If the Pairing process is not completed within two minutes the headset will return to Standby mode. • When using non-G4 scala rider or scala-rider Q2 models to serve as the Passenger unit (e.g. a "Solo", "FM", • or a "TeamSet" Driver unit), Voice Connect Intercom can only be initiated from the scala rider G4 headset.
  • Page 24 For pairing your G4 with another G4 and a scala rider FM headset: 1. Pair your G4 with the second G4 as described in section 9.2a., using CHANNEL A. Pair your G4 with the FM as described in section 9.3b., using CHANNEL B [...

  • Page 25: 10. Notices

    PAGE 25 / 28 10. NOTICES Official Regulatory Notices Federal Communications Commission (FCC) Statement 15.21 You are cautioned that changes or modifications not expressly approved by the part responsible for compliance could | NOTICES void the user’s authority to operate the equipment. 15.105(b) This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules.

  • Page 26: Warranty

    Subject to the limitation set forth in section 10 c below, Cardo Systems, Inc. hereby gives the following warranties: Cardo warrants that the scala rider G4 (the "Product") will be free from defects in materials, design, and workmanship for a period of two (2) years from the date of purchase. Customer must attach proof of purchase to any Product that is claimed to be defective.

  • Page 27: Disclaimer And General Release

    DISCLAIMER AND GENERAL RELEASE By using the scala rider G4 you will waive substantial legal rights including the right to sue. Please read the following carefully before using the device. If you do not accept all terms of this agreement, you should immediately return the product for a full refund.

  • Page 28: Contact And Support

    PAGE 28 / 28 RETURN FOR FULL REFUND IF YOU ARE UNWILLING TO ACCEPT AND AGREE TO THE ABOVE CONDITIONS, YOU MAY RETURN THIS DEVICE TO CARDO FOR A FULL REFUND, PROVIDED THAT YOU DO SO NO LATER THAN 7 BUSINESS DAYS FOLLOWING THE PURCHASE OF THE DEVICE (proof of purchase required) AND SUBJECT TO THE WRAPPING BEING INTACT.

Table of Contents