Making And Receiving Phone Calls; Listening To Music Via A2Dp; Music Sharing - scala rider G9x User Manual

NOTES:
• Not all Bluetooth mobile phones can broadcast Bluetooth Stereo
music (A2DP), even if the phone has an MP3 player function.
Consult your mobile phone's User Manual for more information.
• Not all Bluetooth GPS devices allow connection to Bluetooth audio
devices. Consult your GPS User Manual for more information.
• After pairing, you may need to tap

6.2 MAKING AND RECEIVING PHONE CALLS

Tap
Answer a call
by VOX
Remain silent for 15 seconds, or press
Reject a call
2 seconds
Tap
End a call
Voice Dial* (if supported
Tap
by mobile phone)
mobile
Redial*
Double-tap
Hot Dial Double-tap
†
simultaneously
Set default mobile
‡
While on a phone call, press
In Standby, press
Change default mobile
INTERCOM CONFERENCE MODE
Tap
Add/Remove Channel "A"
to/from a call
Tap
Add/Remove Channel "B"
to/from a call
* This feature is not available during intercom or mobile calls
† Before using Hot-Dial, configure your Hot-Dial number via the Cardo Community.
‡ If you have 2 mobile phones paired directly to your scala rider G9x, you will need
to set one of them to use as default for outgoing calls.
to connect.
or speak any word loudly to answer
and follow the prompt from the
or tap and
for 5 seconds
and for 5 seconds
while on a phone call
while on a phone call

6.3 LISTENING TO MUSIC VIA A2DP

The scala rider G9x can also receive audio via the
enclosed cable from non-Bluetooth MP3 Players or
audio sources as described in section 6.5.
Available only on AVRCP compatible Bluetooth audio sources
Play In standby, press
Pause/Stop Press for 2 seconds or use Voice Command
Next Track With music ON, press
Previous
for With music ON, press
Track*
With music ON, press
Music Scan
The first few seconds of each audio track will be played.
To stop the scan on the current track, say any word loudly into
Stop Scan
the microphone or tap
*With some phones you may need to repeat this action
SWITCHING BETWEEN A2DP AUDIO SOURCES
If a Music Player is paired, the scala rider G9x will use it as the
default A2DP audio source.
1. Stop the music playback from the current device.
2. Start music playback from the other device.

6.4 MUSIC SHARING

Music-sharing allows rider and passenger to listen to the
same music within a range of 33 ft / 10m.
Music sharing works only with A2DP (Bluetooth stereo)
enabled audio sources. In order to share your music with your
riding partner, your scala rider [SENDER] needs to be paired to the
other unit [RECEIVER] on CHANNEL A and the RECEIVER must be in
Standby mode.
for 2 seconds or use Voice Command
for 2 seconds or use Voice Command
for 2 seconds or use Voice Command
(scans up) or (scans down) for 5 sec.
scala rider G9x / G9x PowerSet
®
|
13