Getting Started; General Functions; Status Lights; Audio Sources And Priorities - scala rider G9x User Manual

4. GETTING STARTED

4.1 GENERAL FUNCTIONS

Press
Power ON / OFF
• ON: 3 BLUE flashes + ascending tone
• OFF: 3 RED flashes + decending tone
Volume
Tap or
audio source
Mute
Tap and
Battery level
In Standby, press
indicator
• Blue LED = Full charge
• Purple LED = Half charge
• Red LED = Almost empty
In Standby, press
Enter Settings Menu
follow the spoken instructions
Hear Your Buddy
In Standby, tap
Name
Paired Device
In Standby, press
Indication
If "One+8" Buddies are within range, purple
LEDs flash for 2 seconds
Group Signal
Tap
Enable / Disable VOX
In Standby, press
(For Intercom calls
• Enabled: Blue flash for 2 seconds
only)
• Disabled: Red flash for 2 seconds
Enable / Disable
Press
Spoken Status
Announcements
for 2 seconds
to adjust and set volume of current
simultaneously
for 2 seconds
and for 2 seconds and
and simultaneously
and for 2 seconds
twice
and for 2 seconds
and for 2 seconds

4.2 STATUS LIGHTS

None
1 BLUE flash every 3 seconds
2 BLUE flashes every
3 seconds
1 RED flash every 3 seconds
2 RED flashes every 3 seconds Active mode – Battery is low
Solid RED

4.3 AUDIO SOURCES AND PRIORITIES

If two connected audio sources try to play audio simultaneously,
your scala rider G9x automatically determines which audio
source to play through the speakers based on the priority of the
connected devices.
Higher Priority
 1. Mobile Phone or GPS instructions
2. Intercom
3. A2DP (Stereo Bluetooth) audio
4. FM Radio (Built-in)
5. AUX (for corded connection i.e. Music Players)
*GPS instructions from Smartphone GPS Apps are
Lower Priority
A2DP audio priority can be configured to be higher than Intercom
audio priority via the Cardo Community.
• Incoming mobile phone calls interrupt ongoing intercom calls
• Incoming intercom calls will interrupt ongoing A2DP music
• Click-to-Link, Intercom and "One+8" calls have the same priority:
Click-to-Link requests will not interrupt any type of Intercom call in
progress, and vice-versa
scala rider is OFF
Standby mode – No active audio
Active mode – Call in progress / music
or other audio source is ON
Standby mode – Battery is low
Charging
*
prioritized like A2DP audio
scala rider G9x / G9x PowerSet
®
|
5