Remote Control - Kenmore 580.71056 Owner's Manual

REMOTE CONTROL
Precaution:The Remote Controllerwillnot operate properlyif stronglight strikesthe sensorwindowof the air
conditioneror if there are obstaclesbetweenthe Remote Controllerand the air conditioner.
POWER
• To turn the unit ON, pushthe button.To turnthe unitOFF,
push the button again.
• This button takes priorityover any otherbuttons.
• When you first turn it on, the unitis on the High coolmode
and the temp. at 72°F
TEMPERATURE SETTING
• This button can automatically controlthe temperature
of the room. The temperaturecan be set within a rangeof
60°F to 86°F by I°F.
Select the lower numberfor lowertemperatureof the room.
FAN SPEED
• Everytime you push this button it is set as follows.
(High - Low - High...)
ON/OFF TIMER
- STOPPING OPERATION
• Everytime you push this button, when the unit is operating,
timer is set as follows.
(1Hour- 2Hours - 3Hours - 4Hours -- 5Hours- 6Hours
7Hours_ 8Hours-9Hours -10Hours- 11Hours- 12Hours- Cancel)
• The Setting Temperature will be raised by 2°F 30min. later
and by 2°F after another 30 min.
- STARTING OPERATION
• Everytime you push,this button, when the unit is
not operating, timer is set as follow.
(1Hour- 2Hours- 3Hours- 4Hours- 5Hours- 6Hours
7Hours- 8Hours_gHours- 10Hours--- 11Hours _ 12Hours--- Cancel)
• II
FAN SPEED
TtMER
ENERGY
SAVER
ENERGY SAVER
The fan stops when the compressor stops cooling.
• Approximately every 3 minutesthe fan willturn on and
check the roomair to determine if coolingis needed.
COOL/FAN
• Everytime you push this button, it willtoggle between
COOL and FAN.
MODE
-11 -