Getting Started; Insert Main Battery; Figure 1-4 Mx3X Battery Contacts - LXE MX3X Reference Manual

Getting Started

Getting Started
Note:
This section's instructions are based on the assumption that your new system is pre-configured
and requires only accessory installation (e.g. handstrap, stylus) and a power source. LXE
recommends that installation or removal of accessories be performed on a clean, well-lit surface.
When necessary, protect the work surface, MX3X, and components from electrostatic discharge.
Use this guide as you would any other source book -- reading portions to learn about the MX3X,
and then referring to it when you need more information about a particular subject. This guide
takes you through an introduction to and operation of the LXE MX3X.
In general, the sequence of events is:
1. Insert a fully charged battery and press the Power button.
2. Connect an external power source to the unit (if required).
3. Adjust screen display, audio volume and other parameters if desired.
Note:

Insert Main Battery

Press the Power button after the battery is inserted into the MX3X.
Note:
E-EQ-MX3XRG-A
When your MX3X is pre-configured, the radio, PCMCIA card and endcaps are
assembled by LXE to your specifications.
New batteries must be fully charged prior to use. This process takes up to four hours in
an LXE Multi-Charger Plus and up to eight hours using the MX3X internal charger.
New batteries must be charged prior to first use. This process takes up to four hours in
an LXE Multi-Charger Plus and eight hours with an external power source attached to
the MX3X.

Figure 1-4 MX3X Battery Contacts

5
MX3X Reference Guide