Set Default Parameter - Philips Pocket Memo DPM8500 Configuration Manual

Set Default Parameter

2 Set default parameter
Scan Set Factory Defaults to restore the factory default values listed in
Scan Set Factory Defaults to restore the factory default values listed in the table on page 5.
LED On Time
Parameter # 88h
This parameter sets the maximum time decode processing continues during a scan attempt. It is programmable in 0.1
second increments from 0.50 to 25.5 seconds.
To set an LED On Time, scan the bar code below. Next scan two numeric bar codes beginning on
correspond to the desired on time. Single digit numbers must have a leading zero. For example, to set an on time of 0.5
seconds, scan the bar code below, then scan the "0", "5" and "0" bar codes; to set an on time of 10.5 seconds, scan the bar
code below, then scan the "1", "0" and "5" bar codes. To change the selection or cancel an incorrect entry, scan
page 4-74.
Barcode scanner configuration guide
Table 4-1 on page
Set Factory Defaults
LED On Time
(Default: 3.0 sec.)
4-2.
page 4-73 that
Cancel on
7