SMART Board SB685ix2 User Manual page 87

A P P E N D I X B
Remotely managing your system through an RS-232 serial interface
Setting Use
Projector Name Displays the projector's name
as set by an administrator
(maximum 12 characters).
Location Displays the projector's location
as set by an administrator
(maximum 16 characters).
Contact Displays the contact name or
number for projector support as
set by an administrator
(maximum 16 characters).
Language menu
Language Selects language preference.
Information menu
Lamp Hours Displays the current number of
lamp usage hours from when it
was last reset.
Input Displays the currently displayed
video input source (VGA,
HDMI1, HDMI2 or None).
Resolution Displays the projector's most
recently detected video source
signal resolution and refresh
rate.
77 smarttech.com/kb/170510
Notes
You can set the projector's name using the
remote management features (see Remotely
managing your system through a network
interface on page 47 and Remotely managing
your system through an RS-232 serial
interface on page 57).
You can set the projector's location using the
remote management features (see Remotely
managing your system through a network
interface on page 47 and Remotely managing
your system through an RS-232 serial
interface on page 57).
You can set the contact name or number using
the remote management features (see
Remotely managing your system through a
network interface on page 47 and Remotely
managing your system through an RS-232
serial interface on page 57).
Projector menu support is available in English
(default), Chinese (Simplified), Chinese
(Traditional), Czech, Danish, Dutch, Finnish,
French, German, Greek, Italian, Japanese,
Korean, Norwegian, Polish, Portuguese
(Brazil), Portuguese (Portugal), Russian,
Spanish and Swedish.
Always reset the lamp hours after you replace
a lamp, because lamp service reminders are
based on the current hours of use. See
Resetting the lamp hours on page 29 for
details on the lamp hours reset procedure.
If there is no current video input source signal,
this setting displays the last known source
signal image resolution and refresh rate.