SMART Board SB685ix2 User Manual page 83

A P P E N D I X B
Remotely managing your system through an RS-232 serial interface
Setting Use
V-Position Moves the vertical position of
the source video up or down
from -5 to 5 (relative to the
projected image).
White Peaking Adjusts the image color
brightness from 0 to 10 while
providing more vibrant white
shades.
Degamma Adjusts the color performance
of the display from 1 to 3.
Color Adjusts the Red, Green, Blue,
Cyan, Magenta and Yellow
colors on the projector from 0 to
100 to provide custom color and
luminance output.
Audio menu
Volume Adjusts the projector's volume
amplification from -20 to 20.
Mute Mutes the projector's audio
output.
Disable Volume Disables the projector's volume
Control control and the ECP's volume
control knob.
Selects one or more speakers or
System Output
other audio device.
Projector Functions menu
Auto Signal Enables or disables signal
Detect searching of input connectors.
73 smarttech.com/kb/170510
Notes
Don't adjust this setting unless you're advised
to by SMART Support.
Apply this setting only after you make all
physical adjustments.
This setting applies to VGA inputs only and is
useful in situations where the source video is
cut off.
A value closer to 0 creates a natural image and
a value closer to 10 enhances brightness. The
default is 10.
The default is 2.
Each color has a default value of 100.
Adjustments to the color settings register
under the User mode.
The default is 0.
The default is off.
If you mute the projector's audio output and
then increase or decrease the volume, the
volume is restored automatically. You can
prevent this from happening by disabling the
volume control.
Select Line Out+Speaker, Line Out Only or
Speaker Only.
The default is off.
Select On to have the projector continuously
switch inputs until it finds an active video
source.
Select Off to maintain signal detection in one
input.