Covering Parts - Otto Bock C1000 Service Manual

4.9 Covering Parts

The C1000 has several covering parts at the rear, front and left and right sides of the wheelchair.
Side Covering
The side covering has three attachment points, two at
the top and one at the bottom.
When attaching the covering, make sure that all
cables and plugs are stowed safely behind the
covering and that they are not hindered by the
covering. A 3 mm Allen wrench is required.
Lower Rear Covering
The lower part of the rear covering of the C1000
is attached to the Servotronic holding device from
below. The covering is attached using one slotted
screw at the bottom and one plastic clip on the left
and right sides.
26
Front Covering
The front covering covers the battery case and also
protects it from contamination.
This covering is attached to the frame with four
screws. To tighten or loosen these screws, you need
a 3 mm Allen wrench.
Upper Rear Covering
The upper part of the rear covering is secured with a
thumb screw and hook and loop strap. To remove the
upper covering, first loosen the thumb screw and then
carefully separate the hook and loop connection. Do
not forget to disconnect the lamps when removing the
covering.
When ordering a new rear covering, please indicate
the following:
- Type of seat being used on the C1000 (Recaro® or standard
seat)
- Seat height of the C1000
- Electric seat functions: seat tilt, lift seat device or
electric back?