How To Set The Bios Configuration Jumper; Location Of The Bios Configuration Jumper Block; Jumper Settings For The Bios Setup Program Modes - Intel cc820 Product Manual

Intel Desktop Board CC820 Product Guide

How to Set the BIOS Configuration Jumper

CAUTION
Always turn off the power and unplug the power cord from the computer before changing the
jumper. Moving the jumper with the power on may result in unreliable computer operation.
Figure 15. Location of the BIOS Configuration Jumper Block
This three-pin jumper block, shown in Figure 15, enables all desktop board configurations to be
done in BIOS Setup. Table 7 shows the jumper settings for the Setup program modes.
Table 7.

Jumper Settings for the BIOS Setup Program Modes

Function/Mode
Normal
Configure
Recovery
36
1 3
J7B1
Jumper Setting Configuration
The BIOS uses current configuration information and passwords
1 3
1-2 for booting.
After the POST runs, Setup runs automatically. The
1 3
2-3 maintenance menu is displayed.
The BIOS attempts to recover the BIOS configuration. A
1 3
None recovery diskette is required.
OM08771