Removing Dimms; How To Install The I/O Shield; Installing The I/O Shield - Intel cc820 Product Manual

Intel Desktop Board CC820 Product Guide

Removing DIMMs

To remove a DIMM, follow these steps:
1. Observe the precautions in "Before You Begin" (see Page 21).
2. Turn off all peripheral devices connected to the computer. Turn off the computer.
3. Remove the AC power cord from the computer.
4. Remove the computer cover.
5. Gently spread the retaining clips at each end of the socket. The DIMM pops out of the socket.
6. Hold the DIMM by the edges, lift it away from the socket, and store it in an antistatic package.
7. Reinstall and reconnect any parts you removed or disconnected to reach the DIMM sockets.
8. Replace the computer cover.

How to Install the I/O Shield

The boxed desktop board comes with an I/O shield. When installed in the chassis, the shield
blocks radio frequency transmissions, protects internal components from dust and foreign objects,
and promotes correct airflow within the chassis.
Install the I/O shield before installing the desktop board in the chassis. Place the shield inside the
chassis as shown in the following figure. Press the shield into place so that it fits tightly and
securely. If the shield doesn't fit, obtain a proper-sized shield from the chassis supplier.
28
Figure 8. Installing the I/O Shield
OM07827