Install The Processor; Installing A Processor With A Passive Heatsink - Intel cc820 Product Manual

NOTE
If any fastener (C) gets pushed out of the retention bracket during installation, remove its fastener
retainer pin (D), then press the fastener (C) through the bracket and the hole on the desktop board
until the fastener snaps into place.
4. Push a fastener retainer pin (D) into the hole of fastener (C) until the pin is seated against the
top of the fastener. Repeat this step for each of the fasteners.
5. Align the black retention bracket over the mounting holes at the end of the 242-contact slot
connector near the board edge. Follow steps 3 and 4 to install the retention bracket.

Install the Processor

To install the processor, follow these steps:
1. Insert the processor (A) in the retention mechanism (B). If the processor has a passive
heatsink, see Figure 11. If the processor has an active fan heatsink, see Figure 12.
2. Press down on the processor until it is firmly seated in the processor connector (C).
3. If the processor has an active fan heatsink, attach the fan cable (D) to the desktop board's
processor fan connector at J2M1 (E), as shown in Figure 12.
A
B
Figure 11. Installing a Processor with a Passive Heatsink
Installing and Replacing Desktop Board Components
C
OM08858
31