Boot Menu - Intel cc820 Product Manual

Intel Desktop Board CC820 Product Guide

Boot Menu

This menu is used for setting the boot features and the boot sequence.
Table 22.

Boot Menu

Feature Options
• Disabled
Quiet Boot
• Enabled (default)
• Disabled
Quick Boot
• Enabled (default)
• Disabled (default)
Scan User Flash
Area
• Enabled
• Stays Off
After Power
Failure • Last State (default)
• Power On
• Stay Off (default)
On Modem Ring
• Power On
• Stay Off (default)
On PME
• Power On
• Floppy
1st Boot Device
• ARMD-FDD (Note 1)
2nd Boot Device
• ARMD-HDD (Note 2)
3rd Boot Device
• IDE-HDD (Note 3)
4th Boot Device
• ATAPI CDROM
(This list varies
in length with the • Disabled
number of
devices selected
up to 8.)
Notes:
1. ARMD-FDD = ATAPI removable device - floppy disk drive
2. ARMD-HDD = ATAPI removable device - hard disk drive
3. HDD = Hard Disk Drive. Note that selecting IDE-HDD yields an additional submenu as follows:
Primary Master IDE
Primary Slave IDE
Secondary Master IDE [3
Secondary Slave IDE
54
Description
Disabled displays normal POST messages.
Enabled displays OEM logo instead of POST messages.
Enables the computer to boot without running certain POST
tests.
Enables the BIOS to scan the flash memory for user binary
files that are executed at boot time.
Specifies the mode of operation if an AC/Power loss occurs.
Power On restores power to the computer.
Stay Off keeps the power off until the power button is
pressed.
Last State restores the previous power state before power
loss occurred.
In APM mode only, specifies how the computer responds to
an incoming call on an installed modem when the power is off.
Specifies how the computer responds to a PME (Power
Management Event) wakeup event when the power is off.
Specifies the boot sequence from the available devices. To
specify boot sequence:
1. Select the boot device with <↑> or <↓>.
2. Press <Enter> to set the selection as the intended boot
device.
The operating system assigns a drive letter to each boot
device in the order listed. Changing the order of the devices
changes the drive lettering.
Not all devices in this list are available as second, third, and
fourth boot devices. The default settings for the first through
fourth boot devices are, respectively:
• Floppy
• 1st IDE-HDD
• ATAPI CDROM
• Disabled
st
[1 IDE]
nd
[2 IDE]
rd
IDE]
th
[4 IDE]