Fuser; Error Code And Message; Problems And Solutions - Samsung SCX-6545N Service Manual

4.4 Problems and Solutions

Error Code and Message

Code Errors & Faults
(SEC) message
07-000 Finisher Jam 0
07-001 Finisher Jam 1
07-002 Finisher Jam 2
07-003 Finisher Duplex
Jam
07-004 Finisher Bin Full
07-005 Install Staple
Cartridge
07-006 Close Finisher Door
07-007 Finisher Interface
Error
07-008 Paddle Fault
07-009 Front Jogger Fault
Service Manual
CÓPIA NÃO CONTROLADA
Troubleshooting
Descriptions Solution
Paper jammed in Open Front Cover in Finhsher and
Finisher. remove jammed paper in Finisher or
Fuser area, or uninstall finisher and
remove jammed paper.
Paper jammed in Open Front Cover in Finisher and
Finisher. remove jammed paper in Finisher.
Open front door, lower guied 1a or 1b
then clear
Paper jammed in Pull out jammed paper from Finisher
Finisher. exit
Open Front Cover in Finiser, lower
Paper jammed in
Finisher. Guide1a or 1b, and remove jammed
paper.
Finisher Stack full Remove printed material from Finisher
Stack
Check empty/full Sensor
Staple Cartridge not Install the staple cartridge following the
installed steps explained on the back of the
finisher door.
If you want to continue the print job and
disregard of this error message, go to
Admin Setting to adjust the option.
Finisher Door open Close Finisher Door
Communication error Check/Connect Interface connector.
between Engine and
Finisher
Paddle unit s not Open Finisher Door and check the
operational Finisher, and close the Door
If fault persists, Power Off/Power On
Front Jogger unit s Open Finisher Door and check the
not operational Finisher, and close the Door
If fault persists, Power Off/Power On
4-6
CÓPIA NÃO CONTROLADA
Message
type
Error
Error
Error
Warning
Error
Fault
Fault
Fault
SAMSUNG ELECTRONICS