Samsung SCX-6545N Service Manual page 225

Message
Too much paper in output
bin tray. Remove printed
paper
Top door of scanner is
open
Top door of scanner is
open
Tray 4 door is open.
Close it
Tray2 door is open. Close
it
or
Tray2(HCF) door is open.
Close it
Tray3 door is open. Close
it
Service Manual
CÓPIA NÃO CONTROLADA
Alignment & Troubleshooting
Description
The printed papers are full on the
output tray.
1. DADF door is open during DADF
driving.
2. Platen Door is open during DADF
driving.
DADF door is open
Tray4 door is open.
Tray2 or Tray2 HCF door is open.
Tray3 door is open.
4-100
CÓPIA NÃO CONTROLADA
Suggested solutions
1. Remove the paper on outbin tray.
2. Check the Outbin Full Senosr (Component
Test -> Sensor Read -> OB value)
Close the DADF/Platen door
Close the DADF door.
1. Open and close the door. If the message
is not disappeared, check the below steps.
2. Check that the door switch is pushed.
3. Check that the Ui message is chaged by
door switch action.
4. Check the door switch signal on EDC
mode.
1. Open and close the door. If the message
is not disappeared, check the below steps.
2. Check that the door switch is pushed.
3. Check that the Ui message is chaged by
door switch action.
4. Check the door switch signal on EDC
mode.
1. Open and close the door. If the message
is not disappeared, check the below steps.
2. Check that the door switch is pushed.
3. Check that the Ui message is chaged by
door switch action.
4. Check the door switch signal on EDC
mode.
Samsung Electronics