Samsung SCX-6545N Service Manual page 224

Message
Scanner locking switch
is locked or another
problem occurred.
System error: #02-000.
Please turn off then on
Staple cartridge is empty.
Replace it.
System error: #02-003.
Please turn off then on
System error: #10-004.
Please turn off then on
This IP address conflicts
with an IP address
already in use. Check it
Toner cartridge is not
compatible. Check user's
guide
Toner cartridge is not
installed. Install it.
Toner cartridge is worn.
Replace with new one
Toner cartridge: #06-
006~7. Please turn off
then on
Toner is empty. Replace
toner cartridge
Toner is low. Order new
toner cartridge
Service Manual
CÓPIA NÃO CONTROLADA
Alignment & Troubleshooting
Description
The CCD lock has been locked.
1. At warm up, the temperature is
less than reference temperature
for 20 sec.
2. Abnormal ADC has occurred.
3. ZeroCross Signal detect error has
occurred.
Stapler is run out.
The communication error of the
MEGA88 Micom
UI error
The IP address is used in other place
elsewhere.
The toner cartridge you have
installed is not for your machine.
The toner cartridge is not installed
or the CRUM in the cartridege is not
properly connected.
The color toner cartridge has run out.
The machine stops printing.
Toner Cartridge Error
The lifespan of the color toner
cartridge which the arrow indicates is
reached.
Toner Cartridge is almost empty.
4-99
CÓPIA NÃO CONTROLADA
Suggested solutions
1. Unlock the CCD Lock
2. Check the CCDM. Is is moving when
scanning. Check the FFC cable. If there is
defective, change it.
3. If the problem persists after removing the
FFC cable, replace the DADF board.
4. Check the Scan-motor. If there is
defective, change it.
1. In case of meaning 1, replace the Fuser
unit.
2. In case of meaning 3, replace the Engine
contol board or Fuser control board or
SMPS.
Order Staple cartridge.
1. Open the side cover and close it.
2. Check the envelope pressing device.
1. check the UI connector.
2. If the problem persists, replace the OPE
board.
3. If ther problem persists, replace the maina
board.
Check the IP address or obtain a new IP
address.
Replace the toner cartridge.
Check the connection between the CRUM
connector of the toner cartridge and Set.
Replace the toner cartridge.
Replace the toner cartridge.
Replace the toner cartridge.
Replace the toner cartridge.
Samsung Electronics