Middle Cover; Fuser - Samsung SCX-4828FN/XAZ Service Manual

3.2.5 Middle Cover

1. Remove the 2 screws as shown below.

3.2.6 Fuser

1. Remove the rear cover. Remove the Guide rear
by pushing both side and removing the hinge.
CAUTION
The fuser is very hot. So turn the printer off
and wait until the printer to cool before
replacing it.
Service Manual
Disassembly and Reassembly
2. Remove the 2 screws from the front and rear of
the SET. Unplug the harness connected to the
main board. And lift the middle cover up.
2. Remove the 4 screw. And remove the fuser after
remove the connector.
3-9
Samsung Electronics