Table of Contents
Advertisement
Service Manual – Floortec 760
Main Broom Shaft (Small) Gear Removal/Installation
Disassembly
1
Drive the machine on a level floor and ensure
that it cannot move
2
Turn the ignition key to "0"
3
Remove the hopper by using its transport handle
and wheels
4
Disengage the front fastener and open the
battery/engine compartment hood.
5
Remove the screws (A) and the right side panel
(B) from the machine
6
Remove the rear grid (C) after removing the
upper mounting screw (D) and disengaging the
fasteners
7
Turn the tensioner (E) in the direction shown by
the arrow and disengage the belt (F) from the
pulley (G)
8
Turn the tensioner (H) in the direction shown
by the arrow and disengage the belt (I) from the
pulley (J)
Electrical and Control System
P200317
74
Advertisement
Table of Contents
Troubleshooting
