Dish Network 196812 User Manual page 9

Proper Care of Your Equipment
Always handle the satellite receiver carefully. Excessive shock and vibration can
•
damage the hard drive.
If the equipment is turned on and needs to be moved, unplug the equipemnt and let it
•
sit for at least 30 seconds before moving it.
The use of accessories or attachments not recommended by the receiver
•
manufacturer voids the Limited Warranty.
Do not stack the receiver on top of or below other electronic devices as this can cause
•
heat build-up and vibration.
On some TVs, the presence of fixed images for extended periods of time may
cause them to be permanently imprinted on the screen. Consult your TV user
guide for information on whether this is a problem for your TV, what operating/
viewing restrictions apply to avoid this problem, and associated TV warranty
coverage.
If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
Reorient or relocate the antenna assembly.
•
Increase the separation between the equipment.
•
Connect the equipment into an outlet on a circuit different from that to which the DISH
•
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
•
Note to Satellite TV System Installer: This reminder is provided to call the satellite TV system installer's
attention to Article 820-40 of the National Electrical Code (NEC) that provides guidelines for proper grounding
and, in particular, specifies that the cable ground shall be connected to the grounding system of the building as
close to the point of cable entry as practical
.
Ground Clamp
Antenna Discharge
Unit
Grounding Conductors
(NEC Section 810-21)
Satellite Dish
Coaxial Cable
from Satellite Dish
Electric Service Equipment
Ground Clamps
Power Service Grounding
Electrode System
(NEC Art. 250, Part H)
Safety
vii