Konftel 300IP Installation Manual page 43

PROVISIONING – UPGRADE AND CONFIGURATION
When installation is complete, the text "Upgrade Complete. The unit will be reboot-
ed." is shown in your browser, and after a while you hear the Konftel music signature,
which indicates that the conference phone has started.
Upgrading from downloaded file
It is possible to download a firmware file from www.konftel.com/300ip and install it on the
Konftel 300IP from the local hard disk.
 Download the firmware file from www.konftel.com/300ip.
 Click on the Browse... button and locate and select the downloaded file.
 Click on the Upgrade button.
Upgrading from SD card
Upgrading from SD card may be suitable if you have many phones to upgrade. The phones
do not have to be connected to the network.

Download the latest firmware as above and save it on a SD card.
 Put the SD card in the phone you want to upgrade.
 Disconnect the power supply cable. Note that this is the same as the network cable if
the phone uses Power over Ethernet.
 Press and hold the MENU button while you connect the cable again (i.e. starts the
Konftel 300IP). Hold the button pressed until the SYSTEM RECOVERY menu is shown
on the display.
You can press any other button than 1, 2, or 3 to start the phone without any change.

 Press 2 to select SD-card upgrade.
The Konftel 300IP is upgraded with the firmware file on the SD card and starts when the upgrade
is done.
After upgrading
If DHCP is used in the network, the IP address may have been changed. If the web
browser loses contact with Konftel 300IP, check the IP address on the conference phone
(see "USING THE WEB INTERFACE" on page 6).
41