Location Of The Unit; Leveling The Unit; Height Requirements - Matrix C7xi Owner's Manual

LOCATION OF THE UNIT

Place the unit on a level and stable surface away from direct
sunlight. The intense UV light can cause discoloration on the
plastics. Locate your unit in an area with cool temperatures and
low humidity. Please leave a clear zone behind the unit that is at
least 24" (600 mm). This zone must be clear of any obstruction
and provide the user a clear exit path from the machine. Do not
place the unit in any area that will block any vent or air openings.
The unit should not be located in a garage, covered patio, near
water or outdoors.

LEVELING THE UNIT

Locate a level, stable surface to position the equipment. The
equipment has levelers located below the bottom step. To access
the levelers, remove the end caps (C3X) or CONTROL ZONE
(C5X, C7XE and C7XI). CAUTION: There is an electrical plug
located under the CONTROL ZONE and will need to be unplugged
before the cover can be completely removed. Use an allen wrench
to level the unit. Once stable, replace parts as they were removed.

HEIGHT REQUIREMENTS

The Climbmill adds 30 - 38" (76 - 96.5cm) to a users height.
For example, a 6' (183cm) tall user will be 8'6" - 9' 2" (259.5 -
279.5cm) off the floor.
BEFORE USING THE UNIT
PERFORM INITIAL SETUP.
18
WARNING
Our equipment is heavy, use
care and additional help if
necessary when moving. Failure
to follow these instructions could
result in injury.
WARNING
24" 600 mm
Never operate product if it has a
damaged cord or plug, if it is not
working properly, if it has been
damaged, or immersed in water.
Contact Customer Tech Support
for examination and repair.
AUTO STOP
SENSOR
CONTROL ZONE
(C5X, C7XE, C7XI)