Power Wheels NINJA J8472 Owner's Manual & Assembly Instructions page 10

6
BACK VIEW
• Turn the vehicle upright.
• Fit the handlebar steering column and both connectors down
through the large opening in the front end of the vehicle.
7
BOTTOM VIEW
• Lift the front end of the vehicle up slightly. Check to be sure the
steering column fits through the hole in the steering linkage. Lower
the front end of the vehicle.
• Push down on the handlebar assembly to "snap" it in place.
Steering Column
Connectors
Steering Column
Steering Column Cap
8
• While holding the handlebar in place, carefully turn the vehicle over.
• Again, make sure the end of the steering column is through the hole
in the steering linkage.
• Fit the steering column cap onto the end of the steering column.
• Insert a #8 x 3 / " screw through the large opening in the steering
4
column cap and into the hole in the steering column. Tighten
the screw.
Plate
9
• Slide the plate under the steering column, as shown.
• Insert a #8 x 3 / " into the plate and tighten.
4
10
J8472a-0920