Brush Guard
14
• Fit the brush guard onto the front clip.
• Insert two #8 x
3
/
" screws into the lower holes in the brush guard
4
and tighten.
15
• Insert two #8 x 2" screws into the upper holes in the brush guard
and tighten.
Hand Grip
16
• Fit both hand grips on the ends of the handlebar.
Hint: If it is difficult to slide a hand grip onto the handlebar, moisten
the inside of the grip with water.
Battery Indicator
Connector
(with Orange Tag)
17
• Locate the opening under the drive buttons.
• Reach into the opening and pull the battery indicator connector
and high speed connector out through the opening.
• Plug the battery indicator connector (with orange tag) into the
matching connector (with orange tag). Leave the high speed
connector (with yellow tag) unplugged for now. See page 18 for
information on high speed operation.
12
BACK VIEW
Drive Buttons
Connectors
J8472a-0920
Hand Grip