Power Wheels NINJA J8472 Owner's Manual & Assembly Instructions page 11

Front Axle
10
7
• Slide a / " washer onto the front axle.
16
• Slide a bushing, ring end first, onto the front axle.
• Locate a wheel marked L. Slide the wheel, flat side first, onto the
front axle.
• Slide a wheel cover, indented side out, onto the front axle.
• Slide another 7 / " washer on the front axle.
16
11
SIDE VIEW
• Fit a cotter pin into the hole near one end of the rear axle.
IMPORTANT! Do not force the cotter pin past the third bend.
When correctly assembled to the axle, it should look like the inset
illustration above.
• Repeat steps 10 and 11 to assemble the remaining washers,
bushing, wheel, wheel cover and cotter pin to the other front axle.
Wheel (L)
(Flat Side First)
Washer
Washer
Bushing
(Ring End First)
Wheel Cover
(Indented Side Out)
Third Bend
Cotter Pin
Front Axle
Hubcaps
12
BOTTOM VIEW
• "Snap" a hubcap onto the center of each wheel cover.
• Turn the vehicle upright.
Front Clip
13
• Fit the front clip onto the front of the vehicle, as shown.
Hint: The front clip may already be on the vehicle.
11
FRONT VIEW
J8472a-0920
Hubcaps