Battery Installation - Power Wheels NINJA J8472 Owner's Manual & Assembly Instructions

IMPORTANT! Use only a Power Wheels
rechargeable battery. Use of any other battery will damage your
vehicle. Make sure that you charge the battery for at least 18 hours
using the enclosed Power Wheels
your vehicle for the first time. Charge the battery for at least
14 hours after each use of the vehicle. Never charge the battery
longer than 30 hours. Failure to follow these instructions may
damage your battery and will void your warranty.
1
• Press the tab under the back edge of the seat and lift to remove
the seat.
Power Wheels
12 Volt Battery
Motor Harness
Connector
2
• Lift the battery retainer to access the battery compartment.
• Place the battery upright in the battery compartment.
• Plug the motor harness connector into the battery. Push firmly.

BATTERY INSTALLATION

® 12 volt lead-acid
12 volt charger before operating
®
Seat
® Battery
Retainer
Battery Retainer
3
• Carefully lower the battery into the battery compartment.
The battery retainer slides over the battery to secure it.
Seat
B
4
• Fit the tab at the front of the seat into the slot near the drive
buttons .
A
• "Snap" the tab at the back of the seat into the slot near the rear of
the vehicle .
B
15
Drive Buttons
A
J8472a-0920