Power Wheels NINJA J8472 Owner's Manual & Assembly Instructions page 9

Bushing
(Barrel Side Down)
Slots Up
Wheel Cover
(Indented Side Down)
2
• Slide a 7 / " washer onto the rear axle.
16
• Slide a wheel cover, indented side down, onto the rear axle.
• Locate a wheel marked L. Slide the wheel, indented side down,
onto the rear axle.
• Slide a bushing, barrel side down, onto the rear axle.
• Slide a rear wheel driver, pegged side down, onto the rear axle.
Fit the pegs on the rear wheel driver into the slots in the wheel.
Motor Assembly
3
BOTTOM VIEW
• Position the vehicle upside down.
• Slide the rear axle assembly through the hole in the back end of
the vehicle, as shown. Make sure the rear wheel driver fits into the
pins in the motor assembly inside the vehicle.
Rear Wheel Driver
(Pegged Side Down)
Wheel (L)
(Indented Side Down)
Washer
Rear Axle Assembly
Wheel (R)
(Flat Side First)
Bushing
(Ring End First)
Wheel Cover
(Indented Side Out)
Washer
4
• Slide a rear wheel driver, pegged side out, onto the rear axle.
Make sure the rear wheel driver fits into the pins in the motor
assembly inside the vehicle.
• Slide a bushing, ring end first, onto the rear axle.
• Locate a wheel marked R. Slide the wheel, flat side first, onto the
rear axle. Make sure the pegs on the rear wheel driver fit into the
slots in the wheel.
• Slide a wheel cover, indented side out, onto the rear axle.
• Slide a 7 / " washer onto the rear axle.
16
Rear
Axle
5
• Fit a cotter pin into the hole near one end of the rear axle.
IMPORTANT! Do not force the cotter pin past the third bend.
When correctly assembled to the axle, it should look like the inset
illustration above.
9
Motor Assembly
Rear Wheel Driver
(Pegged Side Out)
Third Bend
Cotter Pin
J8472a-0920