Rigging - Martin MAC 600 NT User Manual

R
IGGING
The MAC 600 (E) NT can be placed directly on the stage floor or rigged in any orientation on a truss. The integrated
Fast-Lock system enables quick and easy fastening of the clamp adapters in 4 different positions as shown below.
The front of the fixture, which is defined as the middle of the pan range, is indicated by an arrow on the base.
safety wire
attachment point
arrow points to front
Warning! Always use 2 clamps to rig the fixture. Lock each clamp with both 1/4-turn fasteners. The
fasteners are locked only when turned fully clockwise.
Warning! Attach an approved safety cable to the base.
To hang the fixture on a truss
1 Verify that the rigging clamps (not included) are undamaged and can bear at least 10 times the weight of the
fixture. Verify that the structure can bear at least 10 times the weight of all installed fixtures, clamps, cables,
auxiliary equipment, etc.
2 Bolt each clamp securely to a clamp bracket with an M12 bolt (grade 8.8 or better) and lock nut.
3 Align a clamp with 2 mounting points in the base. Insert the fasteners into the base and turn both levers a
full 1/4-turn clockwise to lock. Install the second clamp.
4 Block access under the work area. Working safely from a stable platform, hang the fixture on the truss with
the arrow towards the area to be illuminated. Tighten the rigging clamps.
5 Install a safety wire that can bear at least 10 times the weight of the fixture. The attachment point is
designed to fit a caribiner clamp. Never use the carrying handles for secondary attachment.
6 Verify that there are no combustible materials or surfaces to be illuminated within 1 meter of the fixture, and
that there are no flammable materials nearby.
10
(neutral pan)
MAC 600 (E) NT
6