Elite Miracle-One Instruction Manual page 17

C H O O S I N G
Switch the "Open Inside / Open Outside" switch on the control board
to the corresponding position for the proper direction.
MAGLOCK ALARM
SYSTEM
ON
REVERSE
SENSOR
ALARM
SENSOR
OPEN
INSIDE
STOP BY
POSITIVE NO
STOP
ON
60
TIMER
CENTRAL
STRIKE
OPEN
The gate opens inward.
S E N S O R
Caution:
The sensors must be adjusted while the gate is in the opening or closing cycle.
Adjusted by Qualified
Service Personnel
Minimum
Sensitivity
Maximum Sensitivity
Set the sensor adjustment so when the gate hits any object while opening,
it will stop and when the gate hits any object while closing, it will reverse.
Note:
If you activate the operator and the gate stops in the middle of the
driveway, the sensor is set too sensitive.
Important:
It is necessary to still adjust your limit switch at the close position.
The controller will look for the limit close first and then it will look for the positive stop.
G A T E M O V E M E N T
OPEN
OUTSIDE
REPLACE FUSE
WHEN LED IS ON
YES
OFF
3
POWER
CHARGE OK
BAT LOW
CONTROL
SAFETY RADIO CENTER
LOOP REC LOOP
ACCESS SYSTEMS INC ACCESS SYSTEMS INC
MADE IN USA
A D J U S T M E N T
MAGLOCK ALARM
16
D I R E C T I O N
The gate opens outward.
SYSTEM
ON
REVERSE
SENSOR
ALARM
SENSOR
OPEN OPEN
INSIDE OUTSIDE
REPLACE FUSE
STOP BY
WHEN LED IS ON
NO YES
POSITIVE
STOP
ON OFF
60 3
TIMER POWER
CHARGE OK
BAT LOW
CENTRAL CONTROL
STRIKE SAFETY RADIO CENTER
OPEN LOOP REC LOOP
ACCESS SYSTEMS INC ACCESS SYSTEMS INC
MADE IN USA
Stop by Positive - Stop
This option is to be turned to
"yes" if the gate will use
positive stops at the close
position.
Option –