HP iPAQ rx3000 series User Manual page 285

Problem Solution (Continued)
I cannot connect It is likely that the network is a "hidden" or non-SSID broadcast
to an available network. You must know the network name (SSID) to be able to
network that connect.
shows in the list of
1. Tap Start > Settings > Connections tab > Connections
networks without a
> Advanced tab > Network Card.
name.
2. Select Add New Settings.
3. Enter the network name (SSID).
4. Select the appropriate values in the Connects to: box.
5. If WEP settings are required, tap the Authentication tab
and enter them.
I cannot connect • Be sure there is ample signal strength available in the
reliably to an area.
available network
• If you are using one of the WLAN Power Save modes, try
or connections
changing modes or turning off Power Save. Refer to
are frequently
Chapter 10, "Managing the Battery"
dropped.
• If you are using Extended Power Save mode, turn off
Bluetooth.
User's Guide www.hp.com
Troubleshooting
for more information.
12–10