Yamaha 2008 YW50X Service Manual page 37

1 Grip assembly
2 Handlebar switch(right)
3 Front brake light switch
4 Speedometer
5 Rear brake cable
6 Handlebar switch(left)
7 Grip
8 Handlebar assembly
9 Wire harness
0 Throttle cable 1
q Throttle cable 3
w Speedometer cable
e Brake hose
A Route the front brake light
switch lead through between
the handlebar pipe and the
brake hose.
B Route the front brake light
switch lead, left handlebar
switch lead and front turn sig-
nal light lead through the
backward of speedometer
cable .
9
e
w
2
1
q
C Route the front turn signal
light lead through the slot of
handlebar bracket and
through the backward of rear
brake cable.
D Route the left handlebar
switch lead through the back-
ward of handlebar pipe.
E Fasten the throttle cables,
brake hose, wire harness,
speedometer cable and rear
brake cable to the frame and
cut the end to be shorter than
5mm and reserve for a fin-
ger clearance, the position on
the above of guide wire and
align white point mark of wire
harness.
0 q
5
A
3
0
J
I
H
G
CABLE ROUTING
K
B
4
E
9
2-22
SPEC
F Route the speedometer
cable through between the
frame and the brake hose to
right side.
G Route the throttle cable1,3
through between the handle-
bar, wire harness and brake
hose to left side.
H Connect the couplers se-
curely in rear of the brake
hose.
I Pass the throttle cable1,3
through the hole in the
handlebar cover1.
J After adjusting the throttle
cable free play, insert into the
boots.
K After tightening must has
clearance, and tightening
torque 60Nm(6.0m • kg,
43.4ft • lb).
C
6
5
8
D
F
7