Yamaha 2008 YW50X Service Manual page 207

F.O.T FO.. IC"ASI oI
.
Install:
• Inner tube (~
Into outer tube ~).
A
. Install:
• Plain w a s h e r (~
• Bolt ( d a m p e r rod) (~)
4. Tighten:
• Bolt ( d a m p e r rod) (~
~%O%123Nm(2.3 m.kg, 16.6ft.lb) I
NOTE:
Tighten the damper rod bolt ( ~ w h i l e holding the
damper rod with a T-handle(~ and holder ~).
~ T-handle
Y M - 0 1 3 2 6 - A
Holder
YM-01300-1
5. Install:
• Oil seal (~
• Retaining clip
Use the fork seal driver w e i g h t ~) and
the a t t a c h m e n t (~).
NOTE:
\
• Before installing the oil seal (~, apply lithium
soap base grease onto the oil seal lips.
• A d j u s t the retaining clip so that it fits into the
outer tube groove.
6-38
CAUTION:
M a k e sure t h a t t h e oil seal n u m b e r e d side faces
u p w a r d .
~
Fork seal driver w e i g h t :
YM-33963
A t t a c h m e n t :
YM-01400