Special Tools - Yamaha 2008 YW50X Service Manual

EAS00027

SPECIAL TOOLS

The following special tools are necessary for complete and accurate tune-up and assembly. Use
only the appropriate special tools as this will help prevent damage caused by the use of inappropri-
ate tools or improvised techniques. Special tools, part numbers or both may differ depending on the
country.
When placing an order, refer to the list provided below to avoid any mistakes.
NOTE:
8 For U.S.A. and Canada, use part number starting with "YM-", "YU-", or "ACC-".
8 For others, use part number starting with "90890-".
Tool NO.
90890-01235
YU-01235
90890-01337
YM-33285
YM-33285-6
90890-01284
YU-90050
90890-01383
YU-90062
90890-01189
YU-01189
90890-01135
YU-01135-B
90890-01384
YM-33299
90890-01403
YU-A9472
90890-01701
YS-01880-A
Tool name / Function
Rotor holding tool
This tool is used to hold the generator rotor
when removing or installing and generator
rotor bolt.
Clutch spring holder
These tool are used for removing the nut with
holding the compression spring.
Crankshaft installer set 1
Adapter 2
These tools are used to install the crank-
shaft.
Flywheel puller
This tool is used to remove the generator
rotor.
Crankcase separating tool
This tool is used to remove the crankshaft
or separate the crankcase.
Oil seal guide
This tool is used for protecting the oil seal
lip when installing the secondary sliding
sheave.
Steering nut wrench
This tool is used to loosen and tighten the
steering ring nut.
Sheave holder
This tool is used for holding the secondary
sheave.
SPECIAL TOOLS
1
1-5
GEN
INFO
Illustration
2