Yamaha 2008 YW50X Service Manual page 142

V-BELT, CLUTCH A N D
S E C O N D A R Y / P R I M A R Y SHEAVE
I ENG I~=1
S E C O N D A R Y S H E A V E I N S T A L L A T I O N
When assembling the secondary sheave, re-
verse the d i s a s s e m b l y procedure. Note the fol-
lowing points.
. Apply:
• Lithium soap base grease
(to the inside of the sliding/fixed sheave)
2. Install:
• Sliding sheave (~
N O T E :
Be careful so that the oil seal (~ lips are not
turned over w h e n installing the sheave.
3. Apply:
• Lithium soap base grease
(to the torque cam grooves and O-rings)
4. Install:
• Guide pin (~
5. Check:
• Sliding sheave
U n s m o o t h operation-->Repair.
.
Install:
• Clutch securing nut (~
Use clutch spring holder (~
c,utchs0r,n0ho,der s288 l I
. Tighten:
• Clutch securing nut (~
I%~%150 Nm(5.0 m.kg, 36 ft.lb) I
Use Flywheel holding tool
otorho,d,n0too, o01 `0 I
4-21