Yamaha 2008 YW50X Service Manual page 149

co, MAo.ETol E"° I o --I
C.D.I. M A G N E T O R E M O V A L
1. Remove:
• N
ut (~(roto
r)
• Plain washer
N O T E :
Hold the rotor to loosen the nut bythe flywheel
holding tool (~.
I < ~ l Rotor hol d i y u_01235ng tool: I
2. Remove:
• Rotor O
• Wood ruff key
Use the flywheel magneto puller (~.
I < ~ l Flywheel puller: I
YU-01189
• Stator assembly
• Gasket
C.D.I. M A G N E T O I N S T A L L A T I O N
1. Install:
• Gasket (~
2. Apply:
• Lithium soap base grease
(to oil seal)
3. Pass the C.D.I. magneto lead through the
crankcase hole.
4. Install:
• Stator assembly[R e 8 Nm(0.8
m.kg, 5.8 ft.lb) I
5. Install:
• Wood ruff key
• C.D.I. magneto Rotor (~
• Plain washer
•
Nut ~~;~l
38Nm(3.S m.kg, 31.1ft.lb) I
N O T E :
• Clean the tapered portion of the crankshaft
and the magneto rotor hub.
• When installing the magneto rotor, make
sure the woodruff key is properly seated in
the keyway of the crankshaft.
• Do not allow the rotor holding tool to touch
the projection on the magneto rotor.
4-28