Changing light bulbs and installing fog lights
›
Press the locking button
» Fig. 159
1
the socket
.
B
›
Turn the socket
with the bulb counter-clockwise up to the stop and remove.
B
›
Replace the bulb, insert the socket with the new bulb and turn clockwise up to
the stop.
›
Insert the plug
into the socket
A
›
Retighten the screws and insert the cap. The cap must engage firmly.
Changing the licence plate light bulb
First read and observe the introductory information and safety warn-
ings
on page 189.
›
Insert a flat screwdriver into the opening in the area of the arrow
carefully press towards the centre of the lamp, by doing so the lamp jumps out
slightly.
›
Remove the lamp.
›
Remove the faulty bulb from the holder and insert a new one.
›
Replace the glass cover and push in until the stop. Make sure that you install
the glass cover in the correct position.
of the plug
and remove the plug from
A
.
B
Fig. 160
Boot lid: Licence plate light
» Fig. 160
Rear light
Fig. 161 Remove the rear light/install the tail light assembly:
and
First read and observe the introductory information and safety warn-
ings
on page 189.
Bulb arrangement in the tail light assembly
- Rear fog light/Reversing light
1
- Turn signal lights
2
- Brake lights
3
- parking lights
4
Removing and installing the tail light
›
Open the boot lid.
›
Hold the tail light assembly in the installation position with one hand, and re-
move the plastic nut
» Fig. 161
Fig. 162
Tail light assembly: Bulb ar-
rangement
» Fig. 162
- with the other.
Fuses and light bulbs
193