Table of Contents
Advertisement
S
Protective terminal covers, such as rubber boots
on electrical connections, must be in place when
engine is operating or when working in the engine
compartment.
Jumper cables are not ignition-protected. DO NOT
USE jumper cables in the engine compartment. The
engine compartment may accumulate dangerous
explosive gasoline fumes/vapors and hydrogen gas
from batteries being charged. A spark produced
when connecting a jumper cable can cause an
explosion.
3. F
USES
The electronics fuse block is located behind the
access panel below the dash. If you need to replace
a fuse, use only the same amperage as the
original. It is recommended that you carry spare
fuses. See Fig. 6.4.1 for the proper fuse sizes.
E
F
B
LECTRONICS
USE
LOCK
(F
. 6.4.1)
IG
6.4
6 • E
ECTION
S
LECTRICAL
If a fuse is replaced with one of lower amperage,
it will not be suffi cient to carry the electrical load
of the equipment it is connected to and will cause
nuisance fuse failure.
Use of higher amperage fuses or breakers is a fi re
hazard.
Use fuses and breakers having the same amperage
rating as the original or as specifi ed.
If a fuse or breaker is replaced with one of higher
amperage, it will not provide adequate protection
against an electrical malfunction and will create a
fi re hazard.
FUSE NAME
1. VHF
2. GPS
3. DEPTH/SPEED
4. CHART PLOTTER
5. RADAR
6. AUTOPILOT
7. CELLULAR PHONE
8. B & G NETWORK
9. ACCESSORY
10. ACCESSORY
*
(
REFER TO MANUFACTURER'S RECOMMENDATION FOR FUSE RATING
FOR VHF & CHART PLOTTER IF INSTALLED)
F
C
USE
ONDITION
GOOD FUSE
YSTEM
!
WARNING
FUSE AMPERAGE 12VDC
*
N/A
N/A
*
N/A
N/A
N/A
N/A
N/A
N/A
(ATO T
F
)
YPE
USE
BLOWN FUSE
290 Sundancer
®
Advertisement
Table of Contents
