Battery Switch (Only With Ce Option); Ignition Protection; Fuses - Sea Ray 205 Sport Owner's Manual

Hide thumbs Also See for 205 Sport:
Table of Contents

Advertisement

S
B. B
S
ATTERY
WITCH
O
)
PTION
The optional battery switch controls the delivery of
DC power from the batteries to the engine and all
equipment, lights and accessories using DC power.
The battery switch is located on the port hull and
can be accessed by raising the aft jump seat.
NOTE: The bilge pump and stereo memory are not
shut off by the battery switch. This is to permit the
bilge pump to operate at any time excess fluid
accumulates in the bilge, which can occur when
the boat is docked and unattended. The entire
remaining DC system is turned off with the battery
switch.
2. I
P
GNITION
ROTECTION
All electrical components in the engine compartment
must be ignition-protected to avoid the possibility
!
DANGER
GASOLINE VAPORS CAN EXPLODE
Use ONLY Marine-rated parts to replace such items
as starters, distributors, alternators, generators, etc.
Do not use automotive parts for these components
or any jumper cables because they are not ignition-
protected and could cause a fire or explosion.
of creating sparks in a gasoline environment.
Protective terminal covers, such as rubber boots
on electrical connections, must be in place when
engine is operating or when working in the engine
compartment.
Jumper cables are not ignition-protected. DO NOT
USE jumper cables in the engine compartment. The
engine compartment may accumulate dangerous
explosive gasoline fumes/vapors and hydrogen gas
from batteries being charged. A spark produced
when connecting a jumper cable can cause an
explosion.
205 Sport
6 • E
ECTION
(O
CE
NLY WITH
S
LECTRICAL
YSTEM
3. F
USES
If you need to replace a fuse, use only the same
amperage as the original. It is recommended that
you carry spare fuses. See Fig. 6.3.1 for the proper
fuse sizes.
If a fuse is replaced with one of lower amperage, it
will not be sufficient to carry the electrical load of
the equipment it is connected to and will cause
nuisance fuse failure or breaker tripping.
Use of higher amperage fuses or breakers is a fire
hazard.
Use fuses and breakers having the same amperage
rating as the original or as specified.
If a fuse is replaced with one of higher amperage, it
will not provide adequate protection against an
electrical malfunction and will create a fire hazard.
The fuses are color coded according to the
amperage. The rating is marked on each fuse.
F
USES
(F
. 6.3.1)
IG
FUSE NAME
1. HORN
2. IGNITION
3. NAV LIGHTS
4. BILGE BLOWER
5. WIPER
6. BILGE PUMP
7. STEREO
8. 12VDC RECEPTACLE
9. ACCESSORY
10. ACCESSORY
!
WARNING
ATO FUSE
(AUTO TYPE)
FUSE AMPERAGE 12VDC
5
15
10
7.5
5
7.5
5
15
6.3

Advertisement

Table of Contents
loading

This manual is also suitable for:

Mrp 1761654

Table of Contents