Table of Contents
Advertisement
S
3. B
/
REAKERS AND
If you need to replace a fuse or breaker, use only
the same amperage as the original. It is
recommended that you carry spare fuses. See
page 6.5 for the proper breaker and/or fuse sizes.
If a fuse or breaker is replaced with one of lower
amperage, it will not be sufficient to carry the
electrical load of the equipment it is connected to
and will cause nuisance fuse failure or breaker
tripping.
!
WARNING
Use of higher amperage fuses or breakers is a fire
hazard.
Use fuses and breakers having the same amperage
rating as the original or as specified.
If a fuse or breaker is replaced with one of higher
amperage, it will not provide adequate protection
against an electrical malfunction and will create a
fire hazard.
F
C
(ATO T
(F . 6.4.1)
GOOD FUSE
6.4
6 • E
ECTION
F
OR
USES
F
)
BLOWN FUSE
S
LECTRICAL
YSTEM
4. A
CCESSORY
An accessory fuse block holds fuses for equipment
that is not operated by the electronic switch panel.
The fuse block is located inside the control station.
To access the fuse block remove the upper panel
behind the control station in the berth.
A
F
(F . 6.4.2)
F
B
USE
LOCK
B
240 Sundeck
®
Advertisement
Table of Contents
