Fuses - Sea Ray 270 Select EX Owner's Manual

Hide thumbs Also See for 270 Select EX:
Table of Contents

Advertisement

S
Protective terminal covers, such as rubber boots
on electrical connections, must be in place when
engine is operating or when working in the engine
compartment.
Jumper cables are not ignition-protected. DO NOT
USE jumper cables in the engine compartment. The
engine compartment may accumulate dangerous
explosive gasoline fumes/vapors and hydrogen gas
from batteries being charged. A spark produced
when connecting a jumper cable can cause an
explosion.
3. F
USES
Fuses are located in two areas on your 270 SLX.
The accessory fuse block is located behind the
access panel above the Main Distribution Panel in
the STBD Storage area. The access panel can be
removed by removing the four (4) screws that hold
it in place. There are also several fuses on the bilge
A
F
B
CCESSORY
USE
LOCK
A
P
STBD S
CCESS
ANEL IN THE
(F
. 6.3.1)
IG
270 Select EX
6 • E
ECTION
(L
B
OCATED
EHIND
)
TORAGE
SCREWS
S
LECTRICAL
YSTEM
component board (see Fig. 6.4.1). If you need to
replace a fuse, use only the same amperage as
the original. It is recommended that you carry
spare fuses. See Fig. 6.3.1 and 6.4.1 for the proper
fuse sizes.
If a fuse is replaced with one of lower amperage, it
will not be sufficient to carry the electrical load of
the equipment it is connected to and will cause
nuisance fuse failure.
If a fuse or breaker is replaced with one of higher
amperage, it will not provide adequate protection
against an electrical malfunction and will create a
fire hazard.
Use of higher amperage fuses or breakers is a fire
hazard.
Use fuses and breakers having the same amperage
rating as the original or as specified.
FUSE NAME
3. NAV LIGHTS
5. WINDSHIELD WIPER
8. RECEPTACLE
9. TRIM TABS
11. SPOTLIGHT
12. HATCH LIFT
13. DOCKING LIGHTS
15. VHF
16. CO MONITOR
17. CHART
18. ACCY
*
(
REFER TO MANUFACTURER'S RECOMMENDATION FOR FUSE RATING
FOR CHART PLOTTER)
F
C
USE
ONDITION
GOOD FUSE
!
WARNING
FUSE AMPERAGE 12VDC
5
15
10
7.5
5
7.5
10
15
20
10
15
10
10
10
10
1
2
BLANK
(ATO T
F
)
YPE
USE
BLOWN FUSE
6.3

Advertisement

Table of Contents
loading

Table of Contents