Suspended Ceiling T-Bar Installations - Motorola AP-5131 Installation Manual

For standard power adapter (non Power Injector) and line cord installations:
a. Connect a RJ-45 Ethernet cable between the network data supply (host) and the AP-5131
LAN port.
b. Verify the power adapter is correctly rated according the country of operation.
c. Connect the power supply line cord to the power adapter.
d. Attach the power adapter cable into the power connector on the AP-5131.
e. Attach the power supply line cord to a power supply.
CAUTION
10. Verify the behavior of the AP-5131 LEDs. For more information, see "
page 21.
11. The AP-5131 is ready to configure. For information on basic AP-5131 device configuration,
see "
Configuring "Basic" Device Settings
NOTE
3.4.3

Suspended Ceiling T-Bar Installations

A suspended ceiling mount requires holding the AP-5131 up against the T-bar of a suspended ceiling
grid and twisting the AP-5131 chassis onto the T-bar.
The mounting hardware and tools (customer provided) required to install the AP-5131 on a ceiling
T-bar consists of:
• Safety wire (recommended)
• Security cable (optional)
To install the AP-5131 on a ceiling T-bar:
1. If required, loop a safety wire — with a diameter of at least 1.01 mm (.04 in.), but no more
than 0.158 mm (.0625 in.) — through the tie post (above the AP-5131's console connector)
and secure the loop.
2. If required, install and attach a security cable to the AP-5131 lock port.
Do not actually connect to the power source until the cabling portion
of the installation is complete.
If the AP-5131 is utilizing remote management antennas, a wire cover
can be used to provide a clean finished look to the installation. Contact
Motorola for more information.
" on page 25.
Hardware Installation
" on
LED Indicators
15