Motorola AP-5131 Installation Manual page 25

7. Remove the light pipe's rubber stopper (from the AP-5131) before installing the light pipe.
8. Connect the light pipe to the bottom of the AP-5131. Align the tabs and rotate approximately
90 degrees. Do not over tighten.
9. Snap the clips on the light pipe into the bottom of the AP-5131.
10. Fit the light pipe into hole in the tile from its unfinished side.
11. Place the decal on the back of the badge and slide the badge onto the light pipe from the
finished side of the tile.
12. Attach the Radio 1 and/or Radio 2 antennas to their correct connectors.
For information on the antennas available to the AP-5131, see
"
AP-5131 Antenna Options
CAUTION
13. Attach safety wire (if used) to the AP-5131 safety wire tie point or security cable (if used) to
the AP-5131's lock port.
14. Align the ceiling tile into its former ceiling space.
15. Cable the AP-5131 using either the Power Injector solution or an approved line cord and
power supply.
For Motorola Power Injector installations:
" on page 6.
Ensure you are placing the antennas on the correct connectors
(depending on your single or dual-radio model and frequency used) to
ensure the successful operation of the AP-5131.
Light Pipe
Decal
Badge
Hardware Installation
Ceiling Tile
19